Sound sensor
60.00 ৳
In stock
Sound sensor
Sound sensor is used to receive acoustic wave and display the vibration image of sound. It has a build-in capacitively electret microphone that is sensitive to sound. The electret fil min microphone vibrates with the acoustic wave resulting in the change of capacitance and the subsequent micro voltage. Then the micro voltage is sent to LM393 comparator on the module before being compared with the threshold set by the blue potentiometer. When the sound intensity in the surroundings doesn’t reach the threshold, OUT interface outputs high level signals; otherwise, outputs low level signals.
Main Features
Measuring the intensity of sound (Note: only detect the existence of sound according to the principle of vibration);
Adjustable sensitivity (you can use the blue potentiometer shown in the picture);
Working Voltage: 3.3V~5V;
Output Mode: Digital Switch Output (low level under working mode);
Mounting Hole;
Size of PCB: 3.2cm x 1.7cm
Related products
-
LM35 Temperature Sensor
80.00 ৳Add to cartThe LM35 Temperature Sensor are precision integrated-circuit temperature sensors, whose output voltage is linearly proportional to the Celsius or Centigrade temperature. The LM35 thus has an advantage over linear temperature sensors calibrated in Kelvin. the user need not do any external calibration or trimming to provide typical accuracies of ±1⁄4C at room temperature and ±3⁄4C …
-
LDR Sensor Module
55.00 ৳Add to cartLDR Sensor Module Features: Can detect ambient brightness and light intensity Adjustable sensitivity (via blue digital potentiometer adjustment) Operating voltage 3.3V-5V Easy to use with Arduino Output Type: Analog voltage output -A0 Digital switching outputs (0 and 1) -D0 With fixed bolt hole for easy installation Small board PCB size: 3cm * 1.6cm Power indicator …
-
L293D Motor Driver Shield
220.00 ৳Add to cartDescription: L293D Motor Driver/Servo Shield for Arduino This Arduino compatible motor Driver shield is a full-featured products that it can be used to drive 4 DC motors or two 4-wire stepper and two 5V ”hobby” servo. It drive the DC motor and stepper with the L293D, and it drive the servo with Arduino”s pin9 and …
-
RDM 6300 RFID Module 125KHZ
300.00 ৳Add to cartRDM 6300 RFID Module 125KHZ RDM630 125KHz card mini-module is designed for reading code from 125KHz card compatible read-only tags and read/write card . It can be applied in office/home security, personal identification, access control, anti-forgery, interactive toy and production control systems etc. RDM630 Series non contact RFID module, use the advanced RF receiving circuit …
-
Add to cartThis precision sensor is the best low-cost sensing solution for measuring barometric pressure and temperature. Because pressure changes with altitude you can also use it as an altimeter! The sensor is soldered onto a PCB with a 3.3V regulator, I2C level shifter and pull-up resistors on the I2C pins. Specifications: Size: 21mm x 18mm 1.8V …
